Carc Central Community > General

How to assemble 3D starting tile

(1/3) > >>

BBG:
HI. I received 3D the starting tiles but I have no idea how to assemble them. Do I have to use glue to keep the parts together? Otherwise they don't stay in place. Any tips? THANKS!

PS. I've read the attached manual but the "instructions" for assembling are non existant. They say: "assemble the box". Heh. I don't know how.

Linkback: https://www.carcassonnecentral.com/community/index.php?topic=6359.0

Challa007:
Hi there,
no glue is needed and the box normally stays perfectly in place.  :D
You will find the instructions directly on the box itself. See attachment

BBG:
Yeah I followed those instruction and nothing remained in place so I'm missing something.

EDIT. oooh you have to bend the pieces of papers INSIDE i thought it was going to be a closed box  :)) ok ok I did it. Another stupid question... how do I use all the tileholers? They all don't stay inside the assembled box

Challa007:
you need to make sure when you fold the sides that the mini tab at the bottom always goes through the small opening. This is how it is held together .... (see attachment in red)

 And don't confuse outside and inside.... ;)



EDIT: haha, I did not see your reply :) glad you found the trick  ;D

Challa007:
The tile holders have two outer sides and the space for the tiles inside. Fold at the given points and place the tiles between the two outer sides. This means that there is a "floor" on which the tiles are held..... (sorry, difficult to explain)

You can see a picture here:
https://cundco.de/zubehoer/459/3d-startlandschaft-alternativ-inlay?c=113

Navigation

[0] Message Index

[#] Next page